Mr. Copper 2306 Motor

The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime.

Upgraded Asgard, incl.4x35A BLHELI32 ESC, supports ESC Telemetry function.Uses a new Betaflight target, utilising 6x UARTs.

AIO Flight Controller and 4 pcs. BLHELI_S ESC on one PCB, mounting hole 30.5 x 30.5mm. Incl. OSD / SD Card / F4 FC(Target OMNIBUS F4 SD) / Current sensor / BECThe on board ESC supports DSHOT, use J_H_15 firmwareESC tested under 3-4S, 2308 Mo

Upgrade version of OMNIBUS F4, the OMNIBUS F4 Pro (Some shop call it as OMNIBUS F4 PRO V2) added SD card supports, has 5v3A BEC, LC filter for Camera and VTX, build in Current sensor for high Integration Frame.

A new generation AIO Flight control for FPV, based on F405 MCU, using F405 MCU controls OSD over SPI bus in DMA mode, 

OMNIBUS F4's upgrade version, using F405 and new target, with 5x UARTs now.

A new generation AIO Flight control for FPV, based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMA mode, 

BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.

New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.New technology Mosfet, supports up to 50A burst and 45A continued. (ESC mounted under props, without anything covered on the ESC)

BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.